Paper type # 4 G7 ICC profile needed

[disbellj]

I was wondering if anyone would be willing to share the beta ICC profile for paper type # 4 (produced using the G7 method).

I was wanting to move to FOGRA47 since it replaced FOGRA27, but when soft-proofing, I get a cast in the grays and would prefer to trying to match an uncoated G7 profile.

Thank you,

Don

[tmiller_iluvprinting]

Don,
Contact:Joe Fazzi: jfazzi@idealliance.org He can set you up with the G7 Uncoated beta data set.
Best regards,
Todd

[disbellj]

Thank you, Todd. I actually have contacted him a couple times and haven't heard back, so that's one reason I'm asking on here.

Does he have a profile also, or just the dataset?

Regards,

Don

[Bret Hesler]

I believe it is just a data set at this time. They might release a profile after it is finalized, like with the gracol and swop profiles.

Bret

[rich apollo]

Just datasets, and they're not available for public consumption, last I checked.

[disbellj]

Thanks guys.

It sure would be nice to have an aim for uncoated jobs here in the U.S. with a G7 profile available.

I guess I'll stick to FOGRA47 although most likely not as gray balanced.

Regards,

Don

[tmiller_iluvprinting]

Don,
Contact me offline regarding this. Check your messages for contact info.
Regards,
Todd

[disbellj]

Looks good to me. No worries here.

The farthest they are apart is dE 2.991 at Magenta 75%. All other dE76 values are below this (Note: I read 0,10,25,40,50,75, and 100).

See, I just couldn't know without a profile. Now I know I can adjust plate TVI without a press run (just like I did before).

Regards,

Don