Results 1 to 3 of 3
  1. 06-19-2009, 04:25 AM #1
    dnhdesign
    dnhdesign is offline Junior Member
    Join Date
    Jun 2009
    Posts
    1

    Default help! plates too long

    A friend of mine died recently and I am trying to help his wife keep their print business going. They have a Harlequin RIP 4.1 (old I know! running on Windows 98). It is ripping to a PurupEskofot Genesis platemaker but keeps producing the plates at 527mm long (dialog box says 504mm - which is what it should be). I have tried adjusting the menus on the Genesis (film speed, cutter distance) but nothing makes any difference. It must be a setting somewhere on the Harlequin? I know how to edit the .ini file (again it seems to make no difference) ANY advice would be gratefully received!!
    Reply With Quote Reply With Quote
  2. 06-24-2009, 10:59 AM #2
    Tommy B
    Tommy B is offline Member
    Join Date
    Dec 2007
    Posts
    63

    Smile Genesis

    The length of the plate needs to be adjusted in the RIP under the page setup being used. Go into the page setup and change the length there.
    Reply With Quote Reply With Quote
  3. 06-29-2009, 01:56 PM #3
    DonBlock
    DonBlock is offline Senior Member
    Join Date
    Mar 2008
    Location
    Cincinnati, OH
    Posts
    150

    Default

    If the Page Setup is correct in the Configure Device area, the calibration for the Genesis is off and has to be adjusted.
    Reply With Quote Reply With Quote

« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Sponsors


WhatTheyThink Sites