why the film is always stuck if the first time switch on...and in the message :monitor stuck in conveyor
Do you mean the first film that you exposed? How far does it go into the conveyor? Is it in the morning? Maybe your humidity is not correct. It should be 55 +/- 5%.
insert a blank high density diskette into your pc diskette drive.
format it.
extract the zipped file and see the exe file.
double click it. it will ask for diskette. press enter. and wait for installation finished.
in case you want to use harddisk.
it must be less than 1GB clean IDE harddisk (difficult to find). verify it is working on any PC.
connect it via IDE cable to the corresponding slot on your dolev's Cpu board. turn on dolev.
go to BIOS at startup and check that it is configured. if not, configure it as user disk, entering parameters manually.
after it is configured, go to DOS prompt A:/ (during startup press ctrl + E together.)
enter first DOS 6.22 setup disket.
do fdisk and make a standalone primary disk partition, no secondary. then format it.
run setup.
change to second dos 6.22 disket when asked.
change to third dos 6.22 disket when asked.
insert the firmware disket, which you prepared on pc and type install c:
it will install the dolev firmware onto your harddisk. after installation finished, take out the diskette and reboot dolev. now it must boot from harddisk.
you can also install the diagnostics onto the same harddisk. if needed please ask.
your film stuck in conveyor problem may have several causes. can be incorrect leveling between Dolev and online processor. may be humidity problem together with incorrect leveling. because the first film stuck and the others pass.
ok i'll try on sunday....yes,in the morning first time i turn on its stuck and the message no film in but the film enter already...sorry my english not very good
LinkBack URL
About LinkBacks
Reply With Quote
Originally Posted by bramdwi
