4 Visitor Messages

  1. View Conversation
    Remove CP off the prcessor.
    Remove top cover unscrewing 4 screws at corners (back side) and 2 nuts from the DB9 pin plug.
    Remove flex keypad plug off the pins.
    Short cut for a second (use 100 Ohm resistor, not a wire) pins 2 and 4 (counted from the bottom, display window should be on top and face down for proper countdown).
    You have corroded flat silver wires at flex keypad, broken close to the plug.
    To fix that problem you can restore the contacts/wires using Car Rear Window Heater repairing glue (available at any autoparts store)
    Rgds
  2. View Conversation
    Dear Tek,

    please do check your private message.

    regards
    Adnan
  3. Thanks Vlad, It is eduardorevuelta@hotmail.com
  4. View Conversation
    I need your e-mail to send a part of Service Manual concerned the Spinner removal.
    Vladimir.
Showing Visitor Messages 1 to 4 of 4
About tekcontrol

Basic Information

About tekcontrol
Full Company Name (Not Initials)*:
TekControl
Full Job Title*:
General manager
Company Type*:
Print Service Provider

Statistics


Total Posts
Total Posts
64
Posts Per Day
0.06
Visitor Messages
Total Messages
4
Most Recent Message
01-07-2011 02:19 PM
General Information
Last Activity
04-25-2012 03:59 PM
Join Date
04-20-2009

Sponsors

Esko Sponsored Content