Adding print devices in Rampage...

[GTurner]

We just received a new Canon iPF8100 and I need to print to it through my Rampage workflow (Version 10.1b.19) It's been at least 3 years since I've had to do this and I do not remember. Is there anybody out there that can point me in the right direction on how to setup a new print device in Rampage?

[kart97]

If it were just a matter of adding a device it would be simple...
First... it needs to be a supported device to be added. I don't believe that model printer is supported.
That said, do you have another front end for the printer? Most high end plotters can be driven by front ends like GMG, etc.
Good Luck!

[macphenom]

As far as I know Rampage only supports the 8400 and 6400 from Canon and it takes Rampage 10.6 and later to drive them as far as I know.